Dahl Express Service Center: Winona, Minnesota Auto Repair Car Accessories/Shop Online
||

FREE Car Wash With Every Service

Family Owned and Operated Since 1911

No Appointment Necessary

Drive-Ins Welcome

We Service All Makes & Models

Car Care Tips

When Are Your Tires Worn Out?


 

Hey Winona area drivers, are your tires worn out? What is the standard for our MN streets? How can you tell on your vehicle?

While there may be legal requirements for the Winona area, there are safety concerns that go beyond meeting minimum replacement mandates.

Two-thirty-seconds of an inch is the depth of the tire tread wear indicator bars that US law has required to be molded across all tires since August 1, 1968. When tires are worn so that this bar is visible, there's just 2/32 of an inch – 1.6 millimeters – of tread left. It's that level of wear that's been called into question recently.

We're referring to the tread depth on a tire, it can't move surface water out of the way and you start to hydroplane.

In a safety study, a section of a test track was flooded with a thin layer of water. If you laid a dime on the track, the water would be deep enough to surround the coin, but not enough to cover it.

A car and a full-sized pick-up accelerated to 70 miles per hour, or 112 kilometers an hour, and then made a hard stop in the wet test area. Stopping distance and time were measured for three different tire depths:

  • New tire tread depth
  • 4/32 of an inch, or 3.2 mm
  • 2/32 of an inch, or 1.6 mm

So what happened with the 2/32 inch/1.6 mm tires on the car? Get this – when the car had traveled the distance required to stop with new tires, it was still going 55 mph/89 kph. Stopping distance was nearly doubled to 379 feet/116 meters, and it took 5.9 seconds.

Wow! That means if you barely have room to stop with new tires, you would hit the car in front of you at 55 mph/89 kph with the worn tires.

Now, with the partially worn tires – at 4/32 of an inch, or 3.2 mm – the car was still going at 45 mph/72 kph at the point where new tires brought the car to a halt. It took nearly 100 feet, or about 30 meters, more room to stop and 1.2 seconds longer. That's a big improvement. We can see why Consumer Reports and others are calling for a new standard.

Of course, stopping distances were greater for the heavier pick-up truck.

How do you know when your tires are at 4/32 inch or 3.2 mm? Easy; just insert an American quarter into the tread. Put it in upside down. If the tread doesn't cover George Washington's hairline, it's time to replace your tires. With a Canadian quarter, the tread should cover the numbers in the year stamp.

You may remember doing that with pennies. A penny gives you 2/32 inch, or 1.6 mm, to Abraham Lincoln's head. The quarter is the new recommendation – 4/32 inch, or 3.2 mm.

How do people feel about replacing their tires earlier? Well, tires are a big ticket item and most people want to get the most wear out of them that they can. But do you want that much more risk just to run your tires until they are legally worn out?

For us, and we would guess for many, the answer is "no".

Dahl Express Service Center
1111 W. Service Drive
Winona, MN 55987
507-961-1510
http://www.dahlexpresswinona.com

 

Latest Posts

Categories

Automotive News
Cabin Air Filter
Cooling System
Drive Train
Engine Air Filter
Exhaust
Fluids
Fuel Economy
Fuel System
Inspection
Maintenance
Monitoring System
Older Vehicles
Parts
Safety
Serpentine Belt
Service Intervals
Service Standards
Steering
Suspension
Timing Belt
Tires and Wheels
Transmission
Warranty
Windshield Wipers

Archives

December
November
October
September
August
July
June
May
April
March
February
January
December 2016
November 2016
October 2016
September 2016
August 2016